A low nose
Front lips, splitters and low bumpers sit in the road spray and meet driveway lips and kerbs. They collect tar and grit, and they are the easiest part of the car to scuff.
The low supercar wash guide covers how to wash them.
Detailing a Ferrari is the same job as detailing any car, done with less hurry and more questions. Read the paint before touching it, keep every tool that has touched the wheels away from the body, use nothing abrasive on carbon, badges or satin trim, and agree the scope with the owner first.
Our own experience is one car: a Ferrari 296 GTS, one full detail, in Pacific Heights. We have not detailed any other Ferrari model and we say so. If you own one, request a quote so the exact scope is agreed before anything is booked.
A Ferrari does not need ceremony. It needs a careful order of work, a clear conversation about what is on the car, and a detailer who will tell you what they have and have not done.
One job. A Ferrari 296 GTS in Pacific Heights, booked as a full detail, interior and exterior, and done in the owner's garage bay with our own water and power. The case study carries 28 photos of the finished car, 7 inside and 21 outside. There are no before photos, so every frame is labelled a result and the page does not claim a transformation. The same job is on the 296 GTS page and the Ferrari page.
That is the whole list. No other Ferrari model is in our records, and neither is a paint correction, a coating or a film job on a Ferrari. We are a mobile detailing company that also looks after high-value cars. We are not factory-certified by any manufacturer and we are not a Gtechniq accredited installer.
Read what follows as how we work on a car like this, and as a list of questions worth asking any detailer, not as a claim of Ferrari specialism. Our wider exotic and high-end work is on the exotic car detailing page, with the same plain limits.
Front lips, splitters and low bumpers sit in the road spray and meet driveway lips and kerbs. They collect tar and grit, and they are the easiest part of the car to scuff.
The low supercar wash guide covers how to wash them.
Large brakes shed hot, iron-heavy dust onto the wheel faces. Wheel finishes differ, and acid-based cleaners are a common way to stain one, so the finish is worth knowing before anything is sprayed.
A Ferrari can carry exposed carbon in the cabin or on the body. It is a clear layer over a woven fabric: wash it like paint, protect it like paint, and keep abrasives off it.
The carbon fiber care guide goes through it.
Shield badges, lettering and small emblems have edges where polish and cleaner collect. A soft brush and a damp cloth do the work. Scrubbing does not.
Leather, and often suede-like fabric and carbon. Leather conditioner does not belong on the fabric, and the cabin gets very little moisture. The photos from the 296 GTS job show the cockpit, the seats and the centre console.
On a mid-engine car like the 296, the engine cover and rear shoulders hold heat after a drive. Cleaner dries on a hot panel and leaves marks, so the car cools first.
This follows the process on our exotic page: look first, then touch.
Chips, existing swirls, film edges and previous repairs. We point them out before we start, so nobody wonders afterwards what was there before the wash.
A car that has just been driven has hot wheels, hot brakes and a hot rear deck. Wait until the panels are cool to the touch, in shade if you can.
Separate mitts, brushes and towels for the wheels, and they never go near the paint. Brake dust is among the most abrasive things on the car.
A pre-foam and a long rinse take the loose grit off before a mitt touches the paint. Then a two-bucket wash, light pressure, straight lines, lower panels last.
Pat the paint dry. Use a blower or a towel on badges, grilles, vents, mirror bases and shut lines, so water does not run out later and spot.
Vacuum and a soft brush first. Damp, never wet. Leather cleaned gently, suede-like fabric with a fabric-safe cleaner and no conditioner, carbon wiped rather than scrubbed.
A last walk round in natural light, with you if you are there, to check the paint, the glass and the shut lines.
Ferrari owners often garage their cars, so we come to the car. What we ask about is access, not a workshop. A garage bay works if there is room to walk all the way round the car and enough ceiling height for the doors and any raised lid or cover. For an exterior, the water needs somewhere sensible to run off.
Fog, hills, steep driveway lips and street sweeping change the plan more than the badge does. The guide to detailing a supercar in San Francisco covers that, and the guide to two-seater sports cars covers what a small, low cabin changes.
Send the model and year, where the car is kept, what finish the paint and wheels have, and whether it wears film or a wrap. A few daylight photos of the paint help us say what is worth doing.
Book Now covers San Francisco and the northern Peninsula, but a rare or valuable car goes to a quote, so the scope is agreed before anything is booked.
More short answers live on the FAQ.
The services this guide is about:
Back to the full guide library.
A Ferrari wants an unhurried order of work and a clear conversation about what is on the car. We have done one, and we would rather say that than imply more.