Water-based
Usually a natural, low-sheen or satin finish. Cleans up easily and washes off sooner.
A good choice if you prefer a factory look.
Clean first, then dress. A dressing over dirty rubber or old dressing looks patchy, goes brown fast and slings off. Scrub the sidewall with a tire cleaner and a stiff brush until the foam stops turning brown, rinse, and then dress it last, after the rest of the car is washed and dry, with a thin coat from an applicator pad.
Two rules matter more than which product you buy. Keep dressing off the tread and the brakes, because a slick tread is a safety problem, and apply it with a pad rather than spraying freely, because spray ends up on the paint.
Tire dressing is cosmetic. It makes rubber look dark and even. The work that decides how it looks is the cleaning before it.
Tire rubber contains protective compounds that work their way to the surface over time. In sun and air they oxidize into a brownish film. On top of that sit road grime, brake dust and whatever dressing was applied last time, and all of it mixes into the dull gray-brown that tires turn.
That is why scrubbing a tire that looks clean produces brown foam. The brown is the film, and it keeps coming until it is gone. A dressing applied over it just sits on top of the same film, which is why it browns again within days.
San Francisco adds a couple of its own contributions. Hills mean a lot of braking, so there is more brake dust around the tire and the wheel. Fog and sea air keep road film damp and sticky. Tires that sit beside a curb in the sun fade the side that faces out.
Wheels and tires are done before the paint, with their own brushes and mitts that never touch the panels. See the wheels guide.
A dedicated tire cleaner, or an all-purpose cleaner diluted as its label says. Spray the whole sidewall and let it work for the time on the label.
Work the sidewall and the lettering, then rinse. Use a brush that never goes near paint.
On tires that have never been properly cleaned, that can take two or three rounds. The first round often does nothing except lift the top layer.
The back of the arch and the area around the tire hold grime that gets flicked back onto clean tires and panels.
Dressing goes on last. Put it on first and the rinse water washes it off, and the mitt and towels pick it up and carry it onto clean paint.
Dressing on wet rubber runs, streaks and does not bond properly. Dry the sidewall with a towel and give it a few minutes.
A foam pad or applicator, not a free spray. Work it around the sidewall evenly. The sidewall should look dark and even, not wet.
Leave it for a few minutes before driving, and wipe any dressing off the edge of the wheel. Dressing that has not set is what slings onto the paint.
The type changes the look, not whether the tire needs it.
Usually a natural, low-sheen or satin finish. Cleans up easily and washes off sooner.
A good choice if you prefer a factory look.
Usually a glossier, wet look that stays on longer.
It can sling if applied heavily, so keep the coat thin and let it set.
Wheels, tires and arches are cleaned before the paint, with tools that never touch it, and tires are dressed evenly and not slung over the panels. We bring our own water and power, so no hose or outlet is needed at your address.
An Exterior Wash & Protection is $100 on a sedan, $125 on a midsize SUV and $150 on a large SUV or truck.
More short answers live on the FAQ.
The services this guide is about:
Back to the full guide library.
The dressing is the finishing touch. The cleaning is the work.