A halo under the torch
Fine circles over the hood and doors, worst on a dark color, on a car that has been through automatic washes or hand-washed with a dirty mitt.
That is swirl marks, and correction is the answer. Where swirl marks come from.
Do the torch test. After dark, hold a phone flashlight close to the hood and move it around. If you see a halo of fine circular scratching, that is swirl marks, and only machine polishing removes them. If the paint looks deep and clean under that light, you do not need correction, and we will tell you so.
Correction removes clear coat you cannot get back, so it should be the answer to a scratch problem, not to a dirt problem. A lot of paint that looks bad is dirty, rough or unprotected rather than scratched, and all three are cheaper and kinder fixes.
A way to look at your own paint honestly before you spend on the wrong thing.
Overcast daylight hides almost everything, so the lighting matters more than the method.
Dirt, road film and old wax hide scratches and also mimic them. If the car is dirty, wash it, or read the rest of this on a freshly washed one.
Gritty or like fine sandpaper after a wash means contamination bonded to the clear coat, brake dust and fallout and tar. That is a decontamination problem, not a scratch problem.
In a dark garage or at night, hold a phone flashlight close and at an angle to the hood, then move it slowly. A halo or spider-web of fine circles around the light is swirl marks. A single bright point with deep, clear paint around it is not.
Drag a nail across it. If your nail catches, the scratch goes through the clear coat and cannot be polished out; it needs touch-up or paint. If the nail glides over it, it is in the clear coat and may be correctable.
| What you see | What it usually is | What fixes it |
|---|---|---|
| Dull and dirty; clean and shiny after a wash | Road film and lost protection | An exterior wash and protection: $100 / $125 / $150 by size |
| Rough or gritty after washing | Bonded contamination: brake dust, fallout, tar | Iron decontamination ($75 / $100 / $125) and clay bar ($50 / $75 / $100); not correction |
| Orange specks on light paint | Embedded iron particles | Iron decontamination |
| A halo of fine circles under the torch | Swirl marks from washing | Machine polishing: paint correction, quoted |
| Hazy, flat or chalky paint, often a hood or roof | Oxidation or thousands of micro-scratches | Correction, quoted after we see the paint |
| Spots that stay after washing | Minerals on the surface, or etching in the clear coat | Decontamination if they sit on top; polishing if they have etched. Send a photo. |
| A scratch your nail catches | Through the clear coat | Touch-up or paint, not polishing |
| Paint looks deep and clean under the torch | No defect to correct | A good wash, and protection |
Correction is quoted after we see the paint, and it is always paired with at least a 12-month sealant rather than sold on its own.
Machine polishing removes a measured amount of clear coat. That is how it levels a scratch: it lowers the surrounding paint until the groove is gone. The clear coat is finite. A factory finish is roughly 40 to 60 microns and typically supports a couple of full corrections across its whole life, with light one-steps possible more often.
So the answer to a car that does not need correction is not a smaller correction. It is none. We measure the paint rather than assume, and a car that has already been corrected by a previous owner sometimes gets a more conservative recommendation than its swirls alone would suggest.
That is also why the order matters. If paint feels rough, decontamination comes first, and it often changes what you see enough that the correction you were about to buy is no longer needed. Why paint feels rough after washing explains what is happening.
General patterns, not particular customers. Your car may fall between them.
Fine circles over the hood and doors, worst on a dark color, on a car that has been through automatic washes or hand-washed with a dirty mitt.
That is swirl marks, and correction is the answer. Where swirl marks come from.
The paint feels like fine sandpaper after a wash, yet looks clean and deep under the torch.
That is bonded contamination. Decontamination and a clay bar first; it is cheaper and removes no clear coat.
The paint looks glassy under the torch and beads or sheets water.
Nothing to correct. A careful wash and protection keeps it that way, and we will say so rather than sell you a polish.
One-step is a single pass that takes out light swirls, water spots and mild oxidation. Two-step is a cutting pass for deeper defects followed by a refining pass, for heavy swirling, buffer trails or real oxidation. A one-step takes 4 to 6 hours and a two-step 6 to 8 hours or more, depending on the car, and a large vehicle or badly swirled paint can run a full day. One-step versus two-step goes through the choice.
Correction is always paired with at least a 12-month sealant, and if you are planning a ceramic coating it is usually done first, because a coating locks in whatever the paint looks like underneath. Why the two go together.
The correction itself is permanent: the defects removed are gone. What is not permanent is the paint staying that way, because washing and parking keep adding marks. A hand wash with clean media and a protective layer slow that down a lot.
A photo in direct sun, or with a flashlight held close to the hood at night, shows far more than one in overcast light. Send what you have with a quote request and we will tell you honestly whether it is a wash, a decontamination or a correction.
For a quote on correction we look at the paint in proper light before any number is final.
More short answers live on the FAQ.
The services this guide is about:
Back to the full guide library.
Send a photo of the worst panel and we will tell you which of the four fixes it is.