You commented scuff
That white mark down the side of your car is almost never a scratch. It is someone else’s paint sitting on top of yours, and most of it wipes out with a compound and a towel. Here is the exact process from the video, the products I used, and the honest part nobody puts in a Reel: which marks will never polish out.
Step one
Everything below depends on this. Transfer is another car’s paint, a bollard’s paint or a garage wall sitting on your clear coat. Paint loss is your own paint physically gone. They look similar from three feet away and they have completely different outcomes. Go out to the car and check these three things, then read the verdict.
Check the three boxes that apply to your car
The verdict updates as you tick them. Nothing is sent anywhere, and nothing is stored except on this device.
Step two
This is the whole kit. Two compounds, a towel and a machine. Every card opens that product on my gear page, where the current link and price live.
You can do the first half of this with the compound and the towel alone. The machine is only there for the gloss at the end. If you do not own one, do steps one to four, then decide whether the dullness bothers you enough to buy a polisher or book it in.
Step three
Tick each one off as you go. Your progress is saved on this device, so you can put the phone down, do the step, and come back to it.
The honest part
On the car in the video, the transfer came off and two small spots stayed. Those two spots were places where the impact had taken my own paint off, and there is no polish on earth that puts paint back. Polishing removes material, it never adds it.
Comes out with this process
Does not come out, ever
Anything in the right-hand column is a touch-up or a body shop job, not a polishing job. The good news is that clearing the transfer off usually makes the remaining damage far smaller than it looked, which is often the difference between living with it and paying to repaint a panel.
If you detail for a living
You already carry the compound and the machine. Scuff removal takes a fraction of the time a full correction does, the before and after is obvious to the customer standing right there, and it is the kind of result people photograph themselves.
Why it works as a service
Set the expectation first
The products I use are on the gear page, and the way I run a full correction is on the paint correction page.
Questions I get
Only if it is not really a scratch. Most marks that look like a scratch after a scrape are transfer, and those come off. A true scratch is a groove cut into your paint, and a compound cannot fill a groove. The fingernail test tells you which one you have in about two seconds.
The transfer removal in the video was done by hand with a towel. The machine only came out afterwards to bring the gloss back, because a heavy cut compound leaves the paint looking hazy.
So you can absolutely do the important half by hand. You will just be left with a clean but slightly dull patch, which on darker paint is noticeable and on lighter or metallic paint often is not.
For light transfer, yes, and it is the safer place to start. Always try the least aggressive thing first. If the polish is not shifting it after a minute of honest effort, step up to the heavy cut rather than polishing the same spot for ten minutes.
It removes a very small amount of clear coat. That is how it works, and it is why you should not compound the same panel over and over for fun.
Used once to remove transfer, on a panel with a normal factory clear coat, it is a routine correction. Where people get into trouble is leaning hard on one small spot, working on a dry or dirty panel, or going back again and again chasing damage that is never going to come out.
That grey is primer, which means the paint there is gone. Polishing will not bring it back. Your options are a touch-up pen for something small, or a body shop if the area is large or somewhere obvious.
It is still worth removing the transfer around it first, because the remaining damage is almost always much smaller than it looked underneath the mark.
Yes. Send a photo of the panel with a quote request and I will tell you straight whether it is transfer that will come out or damage that needs a body shop, before you pay for anything.
I detail cars around San Francisco and the Peninsula. Send a photo of the panel and I will tell you honestly whether it is coming out before you book anything.
Once a panel has been corrected it is bare, and bare paint picks the next mark up just as easily. A ceramic coating puts a sacrificial layer over the top so the next scrape has something to take instead of your clear coat. It is worth doing on a panel you have just spent an afternoon fixing.
SF City Wash is a mobile detailing business. Gear page links are affiliate links, which cost you nothing extra and help me keep making these breakdowns.