No. Paint correction removes scratches that sit inside the clear coat, and nothing deeper. Swirl marks, wash marring, light scratches and shallow water-spot etching all live in that layer, and machine polishing can level them out. A scratch that has gone through the clear coat into the color coat or the primer cannot be polished out.
The quickest test is a fingernail. Drag it across the scratch: if it catches, the scratch is too deep for polishing, and it needs touch-up or paint, which is body-shop work. We check every panel before we start and tell you which scratches are which, so nothing gets promised that the paint cannot deliver.
This is the honest edge of what machine polishing can do. Knowing where it sits keeps you from paying for a result that was never available, and it tells you what to do with the scratches that are left.
Car paint is a stack. A primer sits on the metal, the color coat sits on the primer, and a clear coat sits over the color. The clear coat is the only layer polishing is meant to touch, and on a factory finish it is roughly 40 to 60 microns thick, thinner than a sheet of paper.
A scratch is a groove. You cannot fill a groove with polish and expect it to stay filled: filler products hide marks for a few washes and then wash out. The permanent fix is to take the surface around the groove down until it is level with the bottom of it. If the groove is shallow, that is a small cut. If the groove runs through the clear coat and into the color, leveling to the bottom would mean removing all of the clear coat in that spot, and nobody can polish their way to a safe result from there.
So the question to ask of any scratch is not how long or how ugly it looks. It is how deep it goes. A long, faint scratch from a wash mitt can disappear completely. A short one from a key or a belt buckle may not move at all, because it goes straight through.
Where a scratch has reached bare metal the issue is no longer cosmetic. Unprotected metal can rust, which is a reason to get the spot repaired rather than polished.
A scratch is a groove, so the useful sort is by how deep the groove is, not by how it got there.
| What you see | Where it sits | Does correction remove it? | What to do about it |
|---|---|---|---|
| Swirl marks, a spider-web haze in low sun | In the clear coat | Yes, in most cases | Machine polishing. This is the common case, and it is what correction is for. |
| Fine marring from a wash mitt, a towel or a dry wipe of a dusty car | In the clear coat | Yes, in most cases | Polishing, then keep a protective layer on the paint. |
| A light scratch your nail glides over | In the clear coat | Usually, depending on depth | Judged panel by panel. It may be softened rather than erased. |
| Water-spot etching you can feel as a ring | In the top of the clear coat | Often, if it is shallow | See the water spot guide for the three levels. |
| A scratch your nail catches in | Through the clear coat, into color or primer | No | Touch-up, paint repair or a body shop. |
| A key, belt-buckle or door-edge scratch | Usually through the clear coat | Usually not; a faint edge may soften | Paint repair. |
| A scuff or paint transfer from another car or a post | On top of the paint, not in it | Often comes off without cutting paint at all | See the scuff and paint transfer guide. |
| A rock chip | A crater rather than a line | No | Touch-up or repair. |
Whether a particular scratch is in the clear coat or through it is judged on the car, under light, panel by panel. This table is the general pattern, not a verdict on your paint.
A rough guide, not a verdict: only a look in person settles it. These five checks sort most scratches into one pile or the other.
Dirt makes scratches look worse than they are and hides their edges. Start with a clean, dry surface.
Swirls and marring show as haze or fine lines in low sun, or under a phone torch after dark, and they come and go as you move your head. A deeper scratch stays visible from almost every angle.
If the nail glides over, the scratch is probably within the clear coat. If it catches in the groove, it has gone deeper and polishing will not remove it. This is the test we use first as well.
A white, grey or differently colored line in the bottom of the scratch usually means the clear coat has been breached and primer or the color coat is showing. A line the same depth of shine as the paint around it is more likely to be in the clear.
Spray a little water over it. If the scratch seems to vanish while wet, it is probably shallow. If it is still obvious wet, it is likely deeper than polishing can safely reach. Treat this as a hint rather than a ruling.
Between gone and unreachable there is a middle group, and it is where most disappointment comes from. A scratch near the bottom of the clear coat's safe working range can come out most of the way and still leave a faint line when the light is right. We would rather leave a faint trace than keep cutting to chase it.
The reason is that clear coat does not grow back. Every pass spends some of a finite amount, which is the subject of the guide on how many times a car can be polished. We stop at the point where the next pass would cost the paint more than the scratch is worth.
Two other things can disappoint. A scratch on a panel that has been repainted or repaired can behave differently from factory paint, because the thickness of the layers may not match the rest of the car. And scratches along panel edges and body lines may be left alone altogether, because paint tends to be thinner there and the risk of cutting through is higher.
None of that changes the plan for the paint as a whole. The swirls and marring across the rest of the car are what make most paint look dull, and those are exactly what correction is for.
We do not offer paint repair or touch-up, so we will not pretend a polish can stand in for either.
Send two photos of the scratch with your quote request, one close and one from a step back, and say whether your nail catches. That is usually enough for us to tell you what to expect, and we confirm on the car before any polishing starts.
Correction is quoted after we see the paint, and it is only sold together with at least a 12-month sealant, so the paint is protected once it has been corrected.
More short answers live on the FAQ.
The services this guide is about:
Back to the full guide library.
We would rather tell you a scratch will not come out than polish it for an hour and leave a faint line you were never warned about. Every correction is quoted after we see the paint.